Daktronics LED Aquatics/Track Displays SW-2000 Series 10 Numeric Digit - Manual (Page 20)

14 Electrical Installation
3.6 Setting Driver Addresses and Protocols
Reference Drawings:
16 Column LED Driver II Specifications ................ Drawing A-126174
Address Configurations, Timing Displays .............. Drawing B-130318
For the scoreboard to receive signal and function properly, the driver must be set to
the correct address and protocol. This address is set with jumper wires in a 12-pin
plug which mates with jack J19 on the driver. Address and protocol plugs are
supplied in a separate kit for field installation. Plugs are marked with address or
protocol numbers. Select the appropriate plugs and connect them to the jacks on the
driver.
The LED scoreboard can be interfaced to a variety of timers. Identify your timer and
refer to the appropriate address configurations for various timing displays. This
information is also presented in the tables at the end of Section 3. (Note that Protocol
1 is used with all Daktronics Omega and Finish Lynx timing systems, Protocol 2 is
used with Colorado Time System units; one-line displays controlled by Daktronics
OmniSport 1000 or 6000 timers require no protocol or address plug; all displays
controlled by the Daktronics OmniSport 2000 require no protocol. OmniSport 2000
requires an address plug for single line displays.
Address settings, LED Fixed-Digit Aquatics/Track Displays
Multi-line Display Addresses
Daktronics Omni Sport 1000
Protocol=1 Address
Function Dec. Binary
Line 1 or 1 and 2 1 00000001
Line 2 or 2 and 3 2 00000010
Line 3 or 3 and 4 3 00000011
Line 4 or 4 and 5 4 00000100
Line 5 or 5 and 6 5 00000101
Line 6 or 6 and 7 6 00000110
Line 7 or 7 and 8 7 00000111
Line 8 or 8and 9 8 00001000
Line 9 or 9 and 10 9 00001001
Line 10 10 00001010
Event/Heat or Home/Guest, Record Time 11 00001011
N.A 12 00001100
Running Time 13 00001101
N.A 14 00001110
Line 4 MS w/ horn 15 00001111