Daktronics DA-1000 Outdoor Decorative Accent - Manual (Page 9)

Installation 3
Section 2: Installation
2.1 Pole Locations
Drawing B-1122070 in Appendix A shows the recommended number of beams and spacing
between them for the various lengths of square and arch truss. While beam placement will be
determined by the dimensions of the overall scoring display, these drawings show where to
expect mounting hardware will typically be attached (so beams may be partially hidden by
the vertical truss, for example).
Note: Refer to any site-specific diagrams for proper placement and mounting method of
display pieces.
Be sure that the installation complies with local building codes and is suitable for the
particular soil and wind conditions. The columns, footings, and all connection details must be
designed and certified by a professional engineer licensed to practice in the state of the
installation.
Note: Daktronics does not assume any liability for any installation derived from the
information provided in this manual or installations designed and installed by others.
Drain Holes
Take care during the installation process to ensure the drain holes in the accent pieces are not
covered by the mounting structure. If they are covered,
3 /
8 " holes must be drilled through the
mounting structure in the same spot as the original holes.