Daktronics DA-1000 Outdoor Decorative Accent - Manual (Page 14)

8 Installation
2.4 Dome Mounting
Two standard mounting methods are available for Daktronics dome decorative accents.
I-Beam Clamps
Mounting hardware includes C-channels; unistrut; spring nuts; I-beam clamps; 1 /
2
-13 x 3"
bolts, flat washers, and lock washers; and 3 /
8
-16 x 1" bolts, flat washers, lock washers, and
nuts. Refer to Figure 8 and one of the following drawings from Appendix A:
Even # of Poles Odd # of Poles
Partial Dome Drawing B-303997 Drawing B-369907
Full Dome Drawing B-1080123 Drawing B-1080180
Note: I-beams must have a flange thickness of 1 /
4
" – 3 /
4
". If flange thickness is greater
than 3 /
4
", longer bolts will be required at added expense.
1. Position the accent at the front of the beams, and lift it to the desired height.
2. Using the C-channel as a template, drill four
7 /
16
" holes in the upper rear flange of the
accent cabinet where the beams will be located.
Note: Try to ensure that the two center holes will be within the width of the beam.
3. Attach the piece of unistrut to the accent cabinet with the included 3 /
8
" hardware, as
shown in Figure 8.
Figure 8: Unistrut Attachment, Side View