Daktronics DA-1000 Outdoor Decorative Accent - Manual (Page 15)

Installation 9
4. Place spring nuts into the unistrut. Twist the spring nuts until they are perpendicular
to the unistrut channel (refer to Figure 5).
Note: Accents require four spring nuts per beam (two at the top and two at the bottom).
5. Slide a lock washer, flat washer, and I-beam clamp onto each bolt, and loosely screw
the bolts into the spring nuts.
6. Position each I-beam clamp assembly as close to the I-beam flanges as possible.
7. Make final adjustments in the positioning of the accent to ensure it is flush and level,
and firmly tighten all of the bolts (Figure 9).
8. Repeat steps 2-7 for the other mounting hardware set on the bottom rear of the accent.
9. Repeat step 8 for all beams.
10. Remove the lift eyebolts and fill remaining holes with silicone.
Figure 9: Dome Accent Mounting with I-beam Clamps, Rear Isometric View