Daktronics LED End-of-Period Basketball Lighting - Manual (Page 11)

Electrical Installation 5
Section 3:
Scorer’s Table Lighting Kit
3.1 Mechanical Installation
Reference Drawings:
Mechanical/Electrical Specs- Light Strip Controller ............................... Drawing A-176435
Mechanical Spec, 5' Sectional Light Strips ............................................ Drawing A-197074
The LED light strip comes with a number of 1" (25 mm) adhesive-backed, hook-and-loop
fastener pieces. Each of these pieces is to be applied to the back or bottom of the LED light
strip and connected to a mating strip that is attached to the scorer's table frame. Two
extended mounting clips come attached to the light strip; these may be removed if desired.
Drawing A-197074 in Appendix A illustrates several variations for the attachment.
A controller box required to run the light strip can either be set on the table (resting on rubber
pads) or mounted under the table using mounting brackets provided with the unit. Drawing
A-176435 in Appendix A shows the attachment of a control box with the mounting brackets.
3.2 Electrical Installation
Reference Drawings:
Installation Details: LED Light Strip Controller ....................................... Drawing B-176174
Mechanical/Electrical Specs- Light Strip Controller ............................... Drawing A-176435
System Riser; EOP LED Lights w/ 4-Sided S.C. .................................... Drawing B-176737
Mechanical Spec, 5' Sectional Light Strips ............................................ Drawing A-197074
The LED light strip is equipped with a 6'-6" (1.98 m) power cord with an XLR plug. This can
be plugged directly into the controller, or the provided 30' (9.1 m) jumper cable can be used
to reach the controller location. As scorer’s table light strips are often installed in pairs, the
controller includes two power output jacks (J21 and J22). The light strip controller is equipped
with a three-prong plug and requires a 120 VAC outlet. Refer to Drawing A-176435 in
Appendix A for details on the light strip controller power and signal connections.
Up to five separate 5' (1.52 m) light strips may be connected from single output on the
controller. Drawing A-197074 in Appendix A illustrates the connections between light strip
sections. The light strip sections may be disconnected and removed from the scorer’s tables
for storage.
Drawing B-176174 in Appendix A provides power and signal installation details for various
light strip controller systems, and Drawing B-176737 provides an overall view of electrical
connections for a typical lighting system.