Daktronics BB-2135 Backboard LED Light Strip - Manual (Page 8)

2 Introduction
1.2 Resources
Figure 2 illustrates a Daktronics drawing
label. The drawing number is located in the
lower-right corner of a drawing. This
manual refers to drawings by listing the
last set of digits and the letter preceding
them. In the example, the drawing would
be referred to as Drawing C-325405.
Reference Drawing:
System Riser Diagram ............................................................................Drawing C-325405
Daktronics identifies manuals by the DD or ED number located on the cover page of each
manual. For example, this manual would be referred to as ED-14187.
1.3 Daktronics Nomenclature
Most components within this device carry a white label that lists the part number of the unit.
If a component is not found in the Replacement Parts List in Section 3.5, use the label to order
a replacement. Figure 3 illustrates a typical label. The part number is in bold.
Main Component Labels
Part Type Part Number
Individual circuit board 0P-XXXX-XXXX
Assembly; a collection of circuit boards 0A-XXXX-XXXX
Wire or cable W-XXXX
Fuse F-XXXX
Transformer T-XXXX
Metal part M-XXX
Fabricated metal assembly 0S-XXXXXX
Specially ordered part PR-XXXXX-X
Accessory Labels
Component Label
Termination block for power
or signal cable TBXX
Grounding point EXX
Power or signal jack JXX
Power or signal plug for the
opposite jack PXX
Following the Replacement Parts List is the Daktronics Exchange Policy and the Repair &
Return Program. Refer to these instructions if replacing or repairing any display component.
Figure 2: Daktronics Drawing Label
Figure 3: Typical Label