D.T. Systems Micro-iDT PLUS with SmartLED - Manual (Page 7)

7
Collar Selecting Switch
Switching between collar units can be
controlled by moving the toggle selection
switch to the desired unit.
Remote Training Buttons
Pressing the “NICK” button will make the Collar Re-
ceiver give a Momentary, or ‘Nick’ Stimulation. Press-
ing the “CONT” button gives a Continuous Stimulation.
Pressing the red button on the left side will make the
collar Vibrate only.
PARTS & FUNCTIONS
Transmitter Antenna
Be sure to check that the Antenna is securely fastened
to the Transmitter before each use. Hand-tightened
only. Be careful when screwing the Antenna into the
Transmitter. Over-tightening the Antenna can cause
damage to the Antenna or the antenna mount.
Magnet Indicator (Red Mark)
The Red Mark indicates the Magnet location
and is used to turn the Collar Receiver ON/
OFF and for ID Programming.
Transmitter LED Indicator Light
When one of the buttons on the Transmitter is pushed,
the red LED light will turn on to indicate that the Trans-
mitter is being operated. If the red LED light blinks
rapidly after pressing any of the Transmitter buttons,
the 9-volt battery will need to be replaced soon.