D.T. Systems Micro-iDT PLUS with SmartLED - Manual (Page 14)

14
PROGRAMMING
When adding an “Add-On” collar, the collar will need to
be programmed to the transmitter. If your current collar
unit is not responding to the transmitter, it may also
need to be reprogrammed to the transmitter.
1. Select the desired Collar Selecting Switch position
on the transmitter.
2. Hold the Transmitter Magnet Indicator (Red Mark)
directly against the Magnetic Switch Indicator (Red
Mark) on the front of the Collar Receiver.
3. The SmartLED light inside the Collar Receiver will
light up solid for about 1 second, followed by 6
flashes. You must keep the Transmitter next to the
Collar Receiver during this time.
4. Continue to hold the Transmitter against the Collar
Receiver until the SmartLED light stays on solid. The
Collar Receiver is now in the Code Running Mode (the
SmartLED light will stay lit for approximately 8
seconds while it is in this mode).
5. Remove the Transmitter from the Collar Receiver
and press the NICK and CONT buttons
simultaneously while it is in the Code Running Mode.
6. When the SmartLED blinks 3 times, the Collar ID
is programmed and the Collar Receiver is now ON.
NOTE – Do not move the Transmitter Magnet Indicator
from the Collar Receiver Magnetic Switch Indicator
until after the SmartLED stops flashing and stays on
solid or the Collar Receiver will not go into the Code
Running Mode. You must press the NICK and CONT
buttons simultaneously while the SmartLED is lit solid.