D.T. Systems Micro-iDT PLUS with SmartLED - Manual (Page 12)

12
TURNING ON AND OFF
The Transmitter is always in a permanent sleep state.
It is only ON when a button is being pressed and does
not need to be turned off by the user.
NOTE
If the SmartLED on the Collar Unit double-flashes while
ON, the unit will need to be recharged. If the SmartLED
double-flashes soon after a full charging session, the re-
chargeable batteries may need to be replaced. If the red
LED on the Transmitter flashes rapidly after any button is
pressed, the 9-volt battery may need to be replaced.
Turning the Collar Receiver ON
1. Hold the Magnet Indicator (Red
Mark) on the Transmitter directly
on the Magnet Switch Indicator
(Red Mark) on the Collar Receiver.
2. The SmartLED light will light up
solid for about one second and then will begin to
flash.
3. Remove the Transmitter away from the Collar
Receiver when the SmartLED light starts flashing.
4. The Collar Receiver is now ON and the SmartLED
light should be flashing.
Turning the Collar Receiver OFF
1. Repeat steps 1-3 above.
2. The Collar Receiver is now OFF and the
SmartLED light should no longer be flashing.