Cybex 751T Treadmill - Manual (Page 19)

Cybex 751T Treadmill Owner’s Manual
19
Assembly and Setup
Warnings/Cautions
All warnings and cautions listed in this chapter are as follows:
WARNING: Serious injury or death can occur. To avoid injury or death the following
procedure must be followed. Use extreme caution when assembling the
treadmill. Failure to do so could result in injury.
WARNING: Serious injury or death can occur. To avoid injury or death the following
procedure must be followed. During this procedure STAY OFF THE
RUNNING BELT! Stand with your feet on the two steps.
CAUTION: Serious injury or damage to machine can occur. To avoid injury or damage the
following procedure must be followed. A minimum of two people are required
to lift, move and assemble this treadmill. Always use proper lifting methods
when moving heavy items.
Choosing and Preparing a Site
Before assembling the treadmill a suitable site must selected and have the proper electrical outlet
power available for optimum operation and safety. See the Electrical Power Requirements section
(located on the next page) for direction in locating the treadmill’s voltage requirements.
The area selected for the treadmill should be well lit and well ventilated. Locate the treadmill on
a structurally sound and level surface (do not place in recessed areas or on plush carpet) a few
feet away from walls and other equipment. Each side of the treadmill should have a 19.7” (0.5
m) minimum space. Behind the treadmill should be 79” (2.0 m) minimum of space. Allow enough
clearance for safe access and passage during use of the machine. If the treadmill is to be located
above the first floor, place it near or above major support beams. If the area has a heavy, plush
carpet, the airflow around the base of the machine may be restricted or the carpeting may interfere
with the moving parts. To protect the carpeting and the machinery, place a 3/4” (1.9 cm) thick wood
base under the treadmill.
Do not install the treadmill in an area of high humidity, such as in the vicinity of a steam room,
sauna, indoor pool, or outdoors. Exposure to extensive water vapor, chlorine, and/or bromine could
adversely affect the electronics as well as other parts of the machine.