beautypg.com

Customer key programming – Dodge 2008 Ram Pickup 1500 User Manual

Page 19

background image

Customer Key Programming

If you have two valid Sentry Keys

௡, you can program

new Sentry Keys

௡ to the system by performing the

following procedure:

1. Cut the additional Sentry Key

௡ Transponder blank(s)

to match the ignition switch lock cylinder key code.

2. Insert the first valid key into the ignition switch. Turn
the ignition switch to the ON position for at least three
seconds, but no longer than 15 seconds. Then, turn the
ignition switch to the LOCK position and remove the first
key.

3. Insert the second valid key into the ignition switch.
Turn the ignition switch to the ON position within 15
seconds. After 10 seconds, a chime will sound. In addi-
tion, the Vehicle Security Light will begin to flash. Turn
the ignition switch to the LOCK position and remove the
second key.

4. Insert a blank Sentry Key

௡ into the ignition switch.

Turn the ignition switch to the ON position within 60
seconds. After 10 seconds, a single chime will sound. In
addition, the Vehicle Security Light will stop flashing. To
indicate that programming is complete, the Vehicle Secu-
rity Light will turn on again for three seconds and then
turn off.

The new Sentry Key

௡ is programmed. The Remote

Keyless Entry (RKE) transmitter will also be pro-
grammed during this procedure.

Repeat this procedure to program up to eight keys. If you
do not have a programmed Sentry Key

௡, contact your

authorized dealer for details.

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

17

2