Dodge 2008 Ram Pickup 1500 - Manual (Page 160)

WARNING!
Vehicle exhaust contains carbon monoxide, a danger-
ous gas. Do not run your vehicle in the garage while
training the transceiver. Exhaust gas can cause seri-
ous injury or death.
Programming HomeLink
ா
Before You Begin
The Compass Mini-Trip Computer (CMTC) illuminates
the HomeLink
௡ symbol (a house with an arrow inside it)
along with 1, 2 or 3 indicators under it, when a
HomeLink
௡ button is pressed.
Pay attention to the indicator(s), as they will flash at
different rates, or remain solid during training.
If you have not trained any of the HomeLink
௡ buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for 20
seconds. Release the buttons when the indicators start to
flash.
It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
to HomeLink
௡, for more efficient training and accurate
transmission of the radio-frequency signal.
Your vehicle should be parked outside of the garage
while training.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8
cm) from the HomeLink
௡ buttons, while keeping the
HomeLink
௡ display in view.
158 UNDERSTANDING THE FEATURES OF YOUR VEHICLE