Fig. 33, Fig. 33a 17 – Danby SPAC8499 User Manual
Page 35
Setting the AUTO-OFF TIMER
Before setting the AUTO-OFF timer, the time of
day clock must be set/operational.
1) To set the AUTO-OFF timer, the unit must be
turned on (I/O switch) and operational.
2) Press the TIMER-OFF key pad to initiate the
AUTO-OFF time sequence. Fig. 33. The display
window will indicate TIMER-OFF and the word
OFF will flash for 5 seconds. Press the or
key pad to select the desired AUTO-OFF time.
Fig. 33a.
key pad will decrease the AUTO-TIMED
setting in 10 minute increments.
keypad will increase the AUTO-TIMED
setting in 10 minute increments.
When the desired time is established, (the time
will flash in the display window) press the
CLOCK key pad to register the AUTO TIMER-
OFF program. The word OFF will stop flashing
and remain “on” (TIMER OFF) indicating the
program is set. The time of day clock setting will
immediately revert back in the display window.
You can varify the AUTO-OFF time selection
anytime by pressing the TIMER-OFF key pad. The
time you selected will appear (flash) temporarily
(replacing the time of day) for approximately 5
seconds.
IMPORTANT: The desired AUTO-OFF time must
be registered within a 5 second period (after
pressing the TIMER-OFF key pad) otherwise the
selected time will not register and the system
will automatically revert back to the regular
“time of day” clock setting. If this occurs, you
must repeat step 2 again.
The unit will stop automatically when the specified
AUTO-OFF time is achieved on the time of day
clock. To cancel or override the AUTO-TIMED
program, simply turn off the unit manually, prior to
the scheduled AUTO-OFF time.
Water Full
Cool/Heat/Dry
I/O
MODE
ON
OFF
SWING
TIMER
CLOCK
FAN
12:00
TIMER
OFF
TEMP./CLOCK
ADJ.
Fig. 33
Water Full
Cool/Heat/Dry
I/O
MODE
ON
OFF
SWING
TIMER
CLOCK
FAN
12:00
TIMER
OFF
TEMP./CLOCK
ADJ.
Fig. 33a
17