Auto-timer instructions, Setting the auto-on timer, Fig. 29 – Danby SPAC8499 User Manual
Page 31: Fig. 30, Fig. 31 air swing mode selection fan speed
Auto-Timer Instructions
NOTE: Auto-Timed programs cannot be set with the
hand held remote control. The TIME OF DAY
CLOCK must be set before the AUTO-TIMER
feature will operate.
The AUTO-TIMER feature offers a unique selection
of multiple choice, fully automatic on/off (start/stop)
programs between 0 - 23 hrs, 50 min. under any one
mode of your Portable 4 Season Home Comfort unit.
The programs are as follows:
a) Auto -Off: Pre-select a time that will turn off the
unit (automatically) at a specified time (between
0 - 23 hrs, 50 min.). This function must be
performed daily, (if required) as the program is
automatically canceled/erased upon completion.
b) Auto-On: Pre-select a time that will turn on the
unit (atomatically) at a specified time (between
0 - 23 hrs, 50 min.). This function must be
performed daily, (if required) as the program is
automatically canceled/erased upon completion.
c) Auto-On & Auto-Off: Pre-select a time that will
turn on and turn off the unit (automatically) at
specified times (between 0 - 23 hrs, 50 min.).
This program contains built-in memory. Unlike
programs a) and b) above. This program
automatically stores into memory the selected
times and will repeat daily, (same specified times)
until the program is overridden and/or canceled.
Any interruption to the electrical power supply
of the unit automatically cancels/erases all
auto timed programs. In the event this should
happen, you will be required to re-set
your program.
Setting the AUTO-ON TIMER
Before setting the AUTO-ON timer, the TIME OF
DAY CLOCK must be set/operational. You must
also select the appropriate MODE and settings (FAN
SPEED, TEMP, SWING etc.) you will require under
the AUTO TIMED program.
1) Turn the unit “on” (I/O switch).
2) Select the appropriate MODE under which
you want the unit to operate (Cool-Dry-Heat-
Fan). Fig. 29.
3) Select the appropriate FAN SPEED setting,
under which you want the unit to operate. (Hi,
Med, Low) (excluding Dehumidifying, as this
mode has “1” fan speed setting only). Fig. 30.
4) If you desire oscillation (auto-swing) push the
SWING key pad (the “air swing” symbol will be
displayed in the display window). Fig. 31.
15
Water Full
Cool/Heat/Dry
I/O
MODE
SWING
TIMER
CLOCK
FAN
12:00
TIMER
TEMP.
ON
MODE
COOL
FAN SPEED
HIGH
00
ON
OFF
TEMP./CLOCK
ADJ.
Fig. 29
Water Full
Cool/Heat/Dry
I/O
MODE
SWING
TIMER
CLOCK
FAN
12:00
TIMER
TEMP.
ON
MODE
COOL
FAN SPEED
HIGH
00
ON
OFF
TEMP./CLOCK
ADJ.
Fig. 30
Water Full
Cool/Heat/Dry
I/O
MODE
SWING
TIMER
CLOCK
FAN
12:00
TIMER
TEMP.
SWING
ON
MODE
COOL
FAN SPEED
HIGH
00
ON
OFF
TEMP./CLOCK
ADJ.
Fig. 31
Air Swing
Mode
Selection
Fan Speed