Cybex 11040 Eagle Leg Press - Manual (Page 12)

12
Cybex Owner’s Manual
5. Remove the three Phillips head screws securing the top (back) shroud and carefully remove the
shroud.
Phillips Head
Screw (3)
6. Loosen but do not remove bottom two screws.
Screw (loosen -
do not remove)
7. Remove the top two screws securing the back shroud.
Screw
8. Slide rear shroud assembly upward and remove.
Install the weight stack
1. Note how the increment weights are installed.
2. With an assistant holding the increment weights, move the adjusting knob to 0 lbs and remove
all six increment weights (three each side.)
3. Using an external snap ring pliers, remove the upper snap ring from one of the guide rods and
carefully lower the guide rod.
Upper snap ring
Lower snap ring
Frame
Guide rod
Wave washer
4. Remove lower snap ring and wave washer from the guide rod. Repeat for the opposite guide
rod.