Cybex 11040 Eagle Leg Press - Manual (Page 11)

11
Cybex Owner’s Manual
12. Move each half through the doorway to the desired location.
13. Attach each half together using the eight BHSCS that were removed.
BHSCS (qty 8)
Nylon Locknut (8)
14. Attach pulley shaft using the pivot shaft and BHSCS that were removed.
BHSCS
Pivot Shaft
Washer
Pulley Shaft
15. Properly route and connect belt to belt clamp.
16. Connect the weight stack belt to the belt clamp of cam.
Set
Screws
Cam
Shield
17. Install shield and secure using the five Phillips head screws.
Install rubber feet
1. Remove each (standard) cone-shaped shipping support using a 3/4” socket or wrench.
2. Cut shipping tie securing top weight.
3. Place rubber feet (supplied with machine) on each foot of the frame.
4. Lift top weight and turn the Increment Weight Adjusting Knob to select 15 lbs (three increment
weights each side.)