Cybex 18080 Bravo Pro - Manual (Page 14)

14
Cybex Owner’s Manual
Install Weight Plates
1. Remove guide rod caps. Guide rod cap contains a compression spring that will fly if grasp
is not released slowly. Slide spring loaded guide rod cap down guide rod until cap is clear of
frame. Slowly release grasp of guide rod cap and remove.
2
3
1
2
1
Description
1 Rod Guide Cap
2 Compression Spring
3 Guide Rods
2. Remove spiral pin securing cable end to top weight using a 3/16” pin punch and hammer.
3
4
1
2
Description
1 Pulley Bracket
2 Cable
3 Top Weight Connector
4 Roll Pin
3. Remove lifting post.
4. Install each weight plate one at a time.
5. Position each weight plate so wide edges of bushings face upward and narrow edges
of bushings face downward.
6. Install lifting post.
7. Snap guide rods into position.