Contemporary Control Systems EISC Configurable Switches Installation Guide - Manual (Page 3)

TD021000-0IF
3
Installation
Mounting
The EISC is designed for mounting in an industrial enclosure or wiring
closet using either set of the provided mounting hardware listed below:
TS-35 DIN Rail Mounting Panel Mounting
DIN rail clip Panel mounting bracket
4-40 screws, pan-head (2) 4-40 screws, flat-head (4)
For quick snap-mounting onto TS-35 mm DIN rail, a DIN rail clip is
pre-attached to the back of the enclosure with two #4-40 pan-head
screws. If the clip is removed, the unit can be panel-mounted by
extending the top and bottom brackets which are shipped in retracted
position. The extended brackets can then anchor the unit to a wall or
other flat surface with two #8 pan-head screws (not provided). The left
illustration of Figure 1 shows a rear view of the unit with brackets in
retracted position. The right illustration of Figure 1 shows the brackets
extended and secured to the unit enclosure using the same screws that
were used in the retracted position.
Figure 1 — Using the Panel-Mounting Brackets