Contemporary Control Systems AI-USB Adapters - Manual (Page 4)

TD030500-0IB
4
INSTALLATION
Mounting
The AI-USB is designed for mounting in a wiring closet or an
industrial enclosure using either set of the provided mounting
hardware listed below:
TS-35 DIN Rail Mounting Panel Mounting
DIN rail clip Panel mounting bracket
DIN rail clip support bracket 4-40 screws, flat-head (4)
4-40 screws, pan-head (2)
For quick snap-mounting to 35 mm DIN rail, a reinforced DIN
rail clip is pre-attached to the back of the enclosure with two
#4-40 pan-head screws. If the clip is removed, the unit can be
panel-mounted by extending the top and bottom brackets which
are shipped in retracted position. The extended brackets can
then anchor the unit to a wall or other flat vertical surface with
two #8 pan-head screws (not provided). The left illustration of
Figure 6 shows a rear view of the AI-USB with brackets in
retracted position. The right illustration of
Figure 6 shows the
brackets extended and secured to the AI-USB enclosure with
the same screws that were used in the retracted position.
Figure 6 — Using the Panel-Mounting Brackets