ConnectGear WA660N - Manual (Page 15)

8
Chapter II: System and Network Setup
2-1 Installing the access point to your Network
Please follow the following instruction to build the network connection
between your new wireless access point and your computers, network
devices:
1. Screw two detachable dipole antennas to the antenna connectors of the
access point.
2. Connect the access point to ADSL modem, router, or switch/hub in
your network through the LAN port of the access point by Ethernet
cable.
3. Connect the power adapter to the wall socket, and then connect it to
the ‘Power’ socket of the access point.
4. Please check all LEDs on the front panel. ‘PWR’ LED should be
steadily on, LAN LED should be on if the access point is correctly
connected to the ADSL modem, router or switch/hub. If PWR LED is
not on, or any LED you expected is not on, please recheck the cabling,
or jump to ‘4-2 Troubleshooting’ for possible reasons and solution.
Note: You must use the power adapter shipped along with the
access point, do NOT use any other power adapter from other
sources.