Comtech EF Data CIC-35 LVDS to ASI - Manual (Page 7)

CIC-35 LVDS to ASI Interface Converter Revision 0
MN/CIC35.IOM
v
IMPORTANT INFORMATION - PLEASE READ
BEFORE INSTALLATION AND USE
S
AFETY
N
OTICES
E
LECTRICAL
S
AFETY
The equipment is rated for operation at +12 volts DC. It has a maximum power
consumption of 2.4 watts. The power supply current is, in all circumstances, supplied by
a single Comtech CDM-600/600L Modem.
Observe the following instructions:
E
QUIPMENT
C
ONNECTION
The CIC-35 is designed for operation ONLY with Comtech CDM-600/600L Modems.
These Modems supply DC operating current (electronically fused and protected) and
control signals for the correct functioning of this unit. Connection to other
manufacturer’s equipment could result in damage to the unit.
E
NVIRONMENTAL
The CIC-35 must not be operated in an environment where the unit is exposed to
temperature extremes outside the ambient range 0 to 50
0 C, precipitation, condensation, or
humid atmospheres above 95% RH, altitudes (un-pressurised) greater than 2000 meters,
excessive dust or vibration, flammable gases, corrosive or explosive atmospheres.
Operation in vehicles or other transportable installations that are equipped to provide
stable environments are permitted. If such vehicles do not provide a stable environment,
safety of the equipment to EN60950 may not be guaranteed.