Compuprint 9058 - Manual (Page 91)

85
Adjusting the Tear-Off Position
HEX DUMP NO
↑
TEAR ADJUST: - 30 → or ←
TEAR ADJUST: ... → or ←
TEAR ADJUST: +360 → or ←
↓
STORE? QUIT
TEAR ADJUST: xxxx These values adjust the distance between the Tear-Off Perforation and the
Tear-Off Bar. The values correspond to 1/180 inch units, i.e. the tuning
ranges between -1/6 and 2 inch. 0 is the default value.
See also “How to Use the Tear-Off Function”, later in this Chapter.