Compuprint 9058 - Manual (Page 129)

123
Messages Indication Solution
DATA SET OFF The DSR Signal is not
connected to the printer and
is not ready for data transfer
(if the serial interface is
selected). This condition may
happen in a remote
connection (via modem) and
the DSR (DATA SET
READY) signal is missing. Press the ON LINE key to reset the error
condition.
INTERLOCK ERROR
CHECK INSERTION Neither the rear tractor nor
the tractor cover are
installed on the printer. Install the rear tractor or the tractor cover
on the printer.
NO PATH AVAILABLE
PATH CHANGING An electromechanical failure
occurs in the lower tractor
paper path. The printer
changes automatically to the
cut sheet paths (Manual or
ASF). Call Service.