Planning for installation, Unpacking, Preparation – Coloronix 12″ Linear RGB Stick User Manual
Page 6: Points to consider about data, Quick step-by-step instructions
Page 6 – Coloronix RGBW Modular Lighting Manual V.2.2
Planning for Installation
Unpacking
Every SDC has been thoroughly tested and has been shipped in perfect operation
condition. Carefully check the shipping carton for damage that may have occurred during
shipping. If the carton appears to be damaged, carefully inspect your controller for any
damage and be sure all equipment necessary to operate the unit has arrived intact. In
case damage has been found or parts are missing, please contact us or your nearest
dealer/distributor for further instructions.
To optimize performance of this product, please read instructions in this manual and on
the case of this product carefully to familiarize yourself with the basic operations. Once the
manual has been thoroughly read, we recommend you file it for future reference.
Caution: There are no user serviceable parts inside this unit. Do not attempt any repairs
yourself: doing so will void your manufacturer’s warranty. In the unlikely event your unit
may require service, please contact Coloronix customer support.
Do not discard the packing carton in the trash. Please recycle whenever possible.
Preparation
Before Installation, Coloronix suggests:
• Consulting the provided submittal drawings to recognize layouts of luminaries,
power supplies, and wiring layouts.
• Drawing out a layout plan consisting of locations of luminaries and wiring.
• Record DMX addresses on a mapping grid for easy reference and addressing
(where applicable).
•
An electrical inspector reviews all wiring plans.
Points to Consider About Data
• Use CAT5 8-wire cable with RJ45 terminators.
•
AC Power and DATA cables may NOT run in the same conduit due to possible
induced errors.
Quick Step-by-Step Instructions
To successfully install RGBW Recessed Lighting, the steps are:
1. Setting Color Mode or Setting Stand Alone ColorRay mode
2. Mounting Miniature Data Enabler
3. Installing Power Connections
4. Installing Data Connections
5. Connect RGB/RGBW Modules
6. Installing Trim
7.
Ready to Go!