Code CR3500 - Manual (Page 9)

C004387_07_CR3500_ User_Manual - 3 Save Settings
1.3 - Battery Installation
Attaching and Detaching the Lithium Ion Battery
The CR3500 can be purchased with a 1950 mAH Lithium Ion battery. To install battery, make sure the battery is in the correct position
(Figure 1.1). Place the plastic tab of the battery into the reader slot (Figure 1.2). Push the battery in and slide the locking mechanism
down (Figure 1.3).
Note: Batteries ships with approximately 50% battery life. Fully charge battery before use. Approximate charge time is 4 hours when
battery depleted.
Charging Options: A CR3500 can be charged, via cable, when connected to a host device. Additionally, Code has a full line of charging
options, please refer to Code’s website at www.codecorp.com. Note: The RS232 interface power adapter must be plugged into a wall
socket for the reader to charge.
Figure 1.1 Figure 1.2 Figure 1.3
1.4 - Attaching Handles
Figure 1.6
1. To attach a Battery Handle, insert the tab on the back of the Battery Handle into the reader’s recessed slot. (Figure 1.4)
2. Press the reader down, towards the handle to snap into place. (Figure 1.5) Optionally, the reader can be further secured
to the handle with two threaded screws on the underside of the reader and handle (screws are included with Battery
Handles). (Figure 6)
3. To detach a Battery Handle, slide the locking mechanism on the reader up and pull the battery handle up and away from
the slot on the reader.
Figure 1.4
1.5 - Powering On/Off Reader
To power on the reader, press and hold either of the red trigger buttons for one
second (Figure 1.7).
The reader will power down after 2 hours of non-use. To change the default
settings, please see Section 4.6 - Reader Power Off Settings.
Figure 1.5
Figure 1.7