Code CR3500 - Manual (Page 15)

C004387_07_CR3500_ User_Manual - 9 Save Settings
1.8.2 - CR3500 as a USB Keyboard
To connect the CR3500 to your host computer via USB interface:
1. Attach the USB cable to CR3500 (Figure 1.13).
2. There is no need to power of the computer (Figure 1.14) Connect the USB cable to a USB port on the computer (Figure 1.15).
3. Once properly connected, the CR3500 will power on and beep.
4. Scan the below code (M049_03) for USB Keyboard Mode:
USB Keyboard Factory Reset Save Settings
7. Scan the Save Settings Code (M188_02)
Figure 1.14 Figure 1.15 Figure 1.13
1.8.2.1 - Addional USB Communication Settings
USB Keyboard Mode - Data is sent from the Reader and interpreted by the host just as if a US
keyboard was being used to enter data.
USB Downloader - This mode is used when downloading firmware.
USB Native Two Way Mode - This mode is utilized when there is a need for error-corrected communication between the CR3500 and
an application through the USB port.
USB Virtual COM 1 Way Mode - This mode allows a USB-cabled CR3500 to function as a virtual COM port. To use the CR3500 in this
mode, download the driver at www.codecorp.com/downloads.php.
USB HID POS (Terminal ID 131) - This mode allows a USB-cabled CR3500 to communicate as a USB HID POS (Terminal ID 131) device.