Code CR3500 - Manual (Page 62)

C004387_07_CR3500_User_Manual - 56 Save Settings
7.2 - General Safety Information
Repairs and Adjustments - Only those individuals authorized by Code should attempt to make repairs or adjustments to CR3500
equipment. If the reader casing is opened the warranty is voided.
Power Supply - Use only the power supply provided for use with each specific reader when operating Code equipment.
Accessories - Only those accessories approved by Code (see page 2) should be utilized with Code equipment.
Non-compliance with any of the above may result in:
• Injury to individuals handling the equipment;
• Damage to the equipment; and
• Voiding of the maintenance contract.
Lithium Ion Battery - Warning: Charge the battery with Code cables ONLY. Do not open battery, dispose of in fire, or short circuit - it
may ignite, explode, leak, or get hot causing personal injury.
7.1 - Reset Reader to Factory Defaults
Scan the following codes to reset reader:
Step 1: Reset the Reader
Reset to USB Factory Reset to PS/2 Factory Reset to RS232 (Serial) Factory
Default Settings Default Settings Default Settings
Reset to RF One Way
Factory Default Settings Bootloader Mode
Step 2: Save Settings
Step 3: Clear All CodeXML® Rules
Prefix & Suffix
Clear All Stored Data
Bootloader mode is
utilized to download new
version of bootloader
firmware.
Note: If you scan these codes, you may
lose your current settings. Make sure to
save settings on your reader before scan-
ning the reset codes.