Code CR4100 Quick Start - Manual (Page 8)

C006244_01_CR4100_QuickStart_Guide
2.5 - Charging the CR4100
1. Make sure a battery is installed in the CR4100 (see Section 2.0 Installing the Battery).
2. Insert the CR4100 into the front charging slot of the Cradle with the screen and keypad
facing forward (Figure 7).
3. The LED on the CR4100 - not the cradle - will illuminate. Refer to the LED Indictor
section (Section 2.3) of this QuickStart Guide for LED charging status/light descriptions.
2.6 - Charging the Spare Battery
1. Align the metal contacts on the battery, such that they make contact with the charging
pins in the cradle.
2. Place the battery into the rear slot on the charging Cradle (Figure 8).
3. The LED on the front of the Cradle will illuminate. Refer to the LED Indictator Section
(Section 2.3) of this QuickStart Guide for the LED charging status/light description on
the Cradle.
2.7 - Charging Cradle Connectors
Connectors are located on the back of the Cradle (Figure 9).
1. 5.2V DC: Insert the barrel jack of the power supply into this connector.
2. USB Client: Connect the communication cable (supplied) to the Cradle and
the host device (PC).
3. USB Host: Can be used to connect peripheral devides, such as keyboards,
to the CR4100.
4. COM: Can be used to connect to peripheral deivces or used to ActiveSync
with host PC.
Figure 7
4
Figure 8
Figure 9