Code CR2500 - Manual (Page 20)

C004386_07_CR2500_User_Manual - 14 Save Settings
1.8.4 - Bluetooth Radio Time Out Settings
Scan the following codes to set the period of time before the Bluetooth Radio will go into sleep mode due to inactivity:
Note: Increasing the time before the reader will time out will decrease battery life.
90 Seconds (Default) 5 Minutes 10 Minutes 15 Minutes
30 Minutes 1 Hour 2 Hours
1.8.5 - Bluetooth Radio Out of Range Notification Settings
Scan the following codes to enable a beep or vibrate notification when the radio goes out of range:
Bluetooth - Out of Range Bluetooth - Out of Range
Beep: On Notify with Vibrate: On
Bluetooth - Out of Range Bluetooth - Out of Range
Vibrate & Beep: On Vibrate and/or Beep: Off (Default)
Note: This feature may also be utilized to remind users they are carrying a reader and help prevent users from walking
away with a reader Bluetooth radio.
If the reader is saved in the proper RF communication mode, enabling this setting will allow the reader to automatically save
the last device to which it was connected, removing the need to scan the save setting after scanning the QuickConnect
code.
Enable Auto Save Disable Auto Save (Default)
1.8.6 - Auto Save Last Bluetooth Address