Cloud Electronics WP-8W - Manual (Page 10)

WP-8 Installation Guide 10
Connecting an external amplifier and/or speakers
The WP-8 is provided with additional outputs, which can be used to drive
external low-power loudspeakers directly, active loudspeakers or the line
inputs of an external amplifier. Both stereo and mono configurations are
possible.
Connections are made to the 6-way screw-terminal block
5
on the rear
PCB. The pinout of this connector block is as follows:
PIN MARKED CHANNEL PURPOSE
1 0V
LEFT
Output – (0 V)
2 L+ Switched output +
3 L+ Permanent output +
4 0V
RIGHT
Output – (0 V)
5 R+ Switched output +
6 R+ Permanent output +
Note that both ‘switched’ and ‘permanent’ outputs are available. The switched
outputs are wired internally via switch contacts on the front panel headphone