12 volt dc connection, Instruction for installing door panel, Changing door swing to opposite side – Dometic RM2652 User Manual
Page 7

7
11. 12 VOLT DC CONNECTION
This refrigerator model is not designed for 12 volt DC
operation of the cooling system; however, 12 volt DC must
be supplied to the refrigerator to operate the controls. Use a
minimum of a 14 gauge wire between the battery and
refrigerator to supply the control voltage. The connection is
made to the positive (+) and negative (–) terminals of the
terminal block on back of refrigerator. (See FIG. 6) The 12
volt DC supply circuit must be fused, and the maximum
fuse size is 5 amps.
DO NOT use the chassis or vehicle frame as one of the
conductors. Connect two wires at the refrigerator and route
to the DC supply.
Clean Direct Current (DC) power is mandatory for high-
tech circuits to operate as designed. The sources for DC
power are a battery and a converter.
A battery will provide straight line DC power, but ex-
tended operation will require recharging of the battery
by the converter or the alternator.
The converter and alternator produces DC power by a
series of diodes that rectify alternating current to DC. A
battery or capacitors can be used to clean up the AC
ripple that is present after AC voltage has been rectified.
12. INSTRUCTION FOR INSTALLING
DOOR PANEL
The refrigerator is normally delivered without the door pan-
els. Before starting the mounting work, check that the panel
dimensions are in compliance with those given in the Table
on this page and the instructions are read thoroughly. When
mounting the panel, proceed as follows. (See FIG. 8)
A.
Remove the trim strip from the door by taking out the 3
screws. See FIG. 8.
B.
Locate the 2 pins in the end frame of the door. If they
are in the top frame, relocate the pins into the holes in
the bottom door frame to support the panel. See FIG.
8.
C.
Slide panel into grooves on vertical edges of the door
until it slips into the groove on the opposite end of door.
D.
Replace trim strip and screws.
13. CHANGING DOOR SWING TO
OPPOSITE SIDE
FIG. 8
Refr. Models HEIGHT WIDTH
TYPE
MAX.
MIN.
MAX.
MIN.
RM2652
upper
mm
403
401
527
524
inch
15-7/8
15-3/4
20-3/4
20-5/8
lower
mm
827
825
527
524
inch
32-11/16
32-5/8
20-3/4
20-5/8
RM2852
upper
mm
403
401
527
524
inch
15-7/8
15-3/4
20-3/4
20-5/8
lower
mm
983
981
527
524
inch
38-11/16
38-5/8
20-3/4
20-5/8
PANEL DIMENSIONS
MAX. THICKNESS 5/32" (4 mm)
The refrigerator is equipped with convertible doors. To
change the door swing, consult the parts manual for
the Conversion Kit Part Number. For further informa-
tion, please contact the Dometic Corporation listed on
the front page.