DigiTech GSP1101 - Manual (Page 7)

Introduction
Congratulations and thank you for purchasing the GSP1101, the rackmount preamp/
processor that works with your existing tone without taking it over.
Please take a moment to make sure you have everything that’s included with your GSP1101
purchase:
GSP1101 Guitar Preamp/Processor
Power cord
Warranty card
USB Driver / X-Edit Editor/Librarian CD
The GSP1101 is extremely easy to use, but we recommend reading this brief manual to
familiarize yourself with the GSP1101’s many features. If you just can’t wait to get started,
refer to the very short Quick Start section below. It’ll get you up and running using a basic
setup in practically no time at all.
Quick.Start
Make Connections - Basic Setup
Make sure your amplifier is turned off and the volume is turned down.
Connect the power cord to the GSP1101’s power input (located on the back panel).
Connect the Left.(Mono).Line.Output (located on the back panel) to the guitar
input of your amplifier.
Connect your guitar to the Input.jack on the front panel.
Turn on the GSP1101.
Turn on your amplifier.
Gradually increase the volume until you reach a comfortable listening level.
Select a Preset
Turn the Edit/Select knob to scroll through different presets. By default, they load
automatically.
Preset Name
Amp Model
Cab Model
Effects (highlighted are active)
•
•
•
•
1.
2.
3.
4.
5.
6.
7.
Introduction
GSP0 Owner’s Manual