Desa CDCFPRA - Manual (Page 23)

www.desatech.com 116658-01C 3
opERaTiNG FiREplaCE
Continued
8. Slightly push in and turn control knob coun-
terclockwise to the ON position.
9. Set flame adjustment knob to any level
between HI and LO.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
Figure 40 - Propane/LP Gas Pilot
Ignitor
Electrode Pilot Burner
Figure 41 - Natural Gas Pilot
Ignitor
Electrode
Pilot Burner
TO TURN OFF GAS
TO APPLIANCe
Shutting Off Fireplace
1. Turn control knob clockwise to
the OFF position.
2.
If Using Optional Hand-Held Remote:
Set se-
lector switch in the OFF position to prevent
draining battery.
Shutting Off burners Only (pilot stays lit)
You may shut off the burners and keep the pilot
lit by doing one of the following:
1. Turn control knob clockwise to
the PILOT position.
2.
If Using Optional Hand-Held Remote:
Use
remote control manual OFF button.
WARNING: Make sure remote
sensor selector switch is in the
OFF position when you are away
from home for long periods of
time.
MANUAL LIGHTING
PROCeDURe
1. Follow steps 1 through 5 under Lighting
Instructions, page 22.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 8 and 9
under Lighting Instructions, column 1.
OPTIONAL HAND-HeLD
ReMOTe OPeRATION
Note: All remote control accessories must be
purchased separately (see Accessories, page 44).
Follow instructions included with the remote
control.
NOTICe: you must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 22.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON position.
Adjust flame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 42).
Note:
The burner may light if hand-held
remote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT:
Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
REMOTE
OFF
ON HI
LO
IN OUT
Figure 42 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
Flame
Adjustment Knob Control
Knob
Selector Switch in Remote Position
(Optional Remote Control)