Caple C710G - Manual (Page 8)

8
INSTRUCTIONS FOR THE INSTALLER
INSTALLATION
Fastening the top
Every cook-top is equipped with a special washer
having.
This must be placed under the edge of the box
unit, as close as possible to the edge itself.
With 70 mm hob, hooks must be placed, with
suitable screws V to the box unit.(fig. 3).
Introduce and place the cook-top in the hole made
in the piece of furniture, then block it with the
screws of the fastening hooks C (fig. 4 or 5).
Gas connection
Make sure that the appliance is adjusted for the
gas type available (see the label under the
appliance). Follow the instructions indicated in the
chapter “gas transformations and adjustments” for
the possible adaptation to different gases. The
appliance must be connected to the gas system by
means of stiff metal pipes or flexible steel pipes
having continuous walls, in compliance with the
regulations in force.
Gas enters the appliance through a cylindrical
threaded male gas union (1/2”).
The connection must not stress the gas ramp.
Once the installation is over, check the connection
seal with a soapy solution.
Electric connection
The connection to the electric grid must be carried
out by qualified personnel and in conformity with
the regulations in force.
The voltage of the electric system must
correspond to the value indicated in the label
under the appliance. Make sure that the electric
system is provided with an effective ground
connction in compliance with the regulations and
provisions of the law. Grounding is compulsory. If
the appliance is not equipped with a plug, apply a
standardized plug to the power supply cable.
It is possible to effect the connection to the electric
grid directly, by interposing an omnipolar switch
having a contact opening distance of at least 3 mm.
5 4
3