Caple C710G - Manual (Page 4)

4
IT IS NECESSARY THAT ALL THE OPERATIONS REGARDING THE INSTALLATION, ADJUSTMENT
AND ADAPTATION TO THE TYPE OF GAS AVAILABLE ARE CARRIED OUT BY QUALIFIED
PERSONNEL, IN CONFORMITY WITH THE REGULATIONS IN FORCE.
THE SPECIFIC INSTRUCTIONS ARE DESCRIBED IN THE BOOKLET SECTION
INTENDED FOR THE INSTALLER
INSTRUCTIONS FOR THE USER
USING THE BURNERS
The symbols silk-screen printed on the side of the
knob indicate the correspondence between the
knob and the burner.
Manual ignition
Press the knob and turn it anticlockwise until it
reaches the symbol on the control panel
(maximum flame position) and place a lighted
match or lighter near the burner.
Electrical ignition
Press the knob and turn it anticlockwise until it
reaches the symbol on the control panel
(maximum flame position) and press the button on
the control panel.
Automatic electrical ignition
Press the knob and turn it anticlockwise until it
reaches the symbol on the control panel (maximum
flame position) and then depress the knob.
On those models fitted with a safety device,
the knob must be pressed in for about 6
seconds once the burner has ignited.
Using the burners
In order to obtain the maximum yield without waste
of gas, it is important that the diameter of the pot is
suitable for the burner potential (see the following
table), so as to avoid that the flame goes out of the
pot bottom (fig.1).
Use the maximum capacity to quickly make the
liquids reach the boiling temperature, and the
reduced capacity to heat food or maintain boiling.
All of the operating positions must be chosen
between the maximum and the minimum ones,
never between the minimum position and the
closing point.
The gas supply can be interrupted by turning the
knob clockwise up to the closing position.
Burners Power W ø of pots
Auxiliary 1000 10-14 cm
Semi-rapid 1400/1650 16-18 cm
Rapid 2600/2900 20-22 cm
Ultra-rapid 3500 24-26 cm
1