Campomatic PI200 - Manual (Page 9)

8
SET PCODE - and the “-” flashes.
2. Press Ÿ or ź key to set PABX code from 0 to 9 or -.
3. If choose “-”, it means no PABX code has been set.
4. Press SET key to confirm and quit.
HOLD ON MUSIC
¾ Hold music selection
There are 3 kinds of hold music for selection
1. At off-hook or hands free state, press HOLD key
2. Press OUT key to select the desired hold music. It plays the music at same time.
3. Press Ÿ or ź key to select the 4 steps volume of hold music.
4. Press HOLD key to quit.
¾ When talking over handset, press HOLD key to enter the hold mode and the hold music
is sent out. In hold mode
1. Press HOLD key to release hold mode and continue to talk over handset, or
2. Hang up handset, it enters hands-free hold mode.
¾ When talking at hands-free mode, press HOLD key to enter the hold mode and the hold
music is sent out. In hold mode
1. Pick up handset to talk over handset, or
2. Press key to quit hold mode and talk at hands-free mode.
LOW BATTERY DETECTING
When the voltage is lower than 3.9 v, LCD displays “ ” icon to remind the user to replace the
batteries.
LCD BACKLIGHT FUNCTION
The backlight is turned on when receiving an incoming call, dialing, pressing any key or in MUSIC
HOLD mode. It will fade off if the telephone is left idle for 10 seconds.
NOTE: If batteries are not loaded, there will be no LCD backlight function.
FLASH FUNCTION
When dialing a number and the line is engaged, press FLASH key and then press REDIAL key to
dial it out again.
PAUSE FUNCTION
If dial a number from PABX extension, press PABX number (normally “0” or “9”) + ALARM +
desired number. When redial, need not dial PABX number and ALARM key, just press REDIAL
key.