Campomatic PI200 User Manual
Page 8
7
2. Key in “
” and the paging number (example “ 1”and ” 2” ), using DEL key to edit
3. Press SET key to confirm and exit.
¾ Transferring the line from paralleled phones
When a call comes, use one of paralleled phones to answer. Press “
” and the paging number that
was set in another telephone unit, the unit rings, pick up its handset or press
key to answer the
incoming call.
Notice: Please use same series phones to transfer as above operation. Any special
services starting with “
*
” offered by your Telephone company may not function properly.
To get the best effect of this function, you should load the batteries before using.
ANTI-DIALING FROM PARALLEL PHONES
1. In on-hook state, press and hold # key for 3 seconds, LCD displays SPI ON
2. Press key twice and then
3. Press and hold # key for 3 seconds again, LCD displays SPI OFF
When the anti-steal is set to ON, users who want to dial using an extension via the same line will
hear a “di-di, di-di” beep continuously and will not be allowed to make a call.
SETTING RINGING TONE AND ADJUST RINGING VOLUME
There are 16 kinds of ringing tones for selection:
1. In on-hook state, press RING key, LCD displays ring 02 db8
2. Press RING to select the desired ringing or set ring OFF
3. Press
Ÿ or ź key to set ringing volume
4. Press
SET to confirm and exit.
NOTE: The volume ranges from 1db-8db, with 8db being the loudest. Ring OFF is “Do Not
Disturb” mode. If the phone is set to this mode, the telephone will not ring when there is an
incoming call.
ADJUST HANDSFREE VOLUME
In handsfree mode, press
Ÿ or ź to adjust the handsfree volume, LCD displays the volume level
and there is a total of 3 levels.
SELECTING PULSE OR TONE DIALING MODE
1. In on-hook state, press and hold
key for 3 seconds, LCD displays P, then dialing mode is set
as Pulse.
2. Press key twice and hold
key for 3 seconds again, LCD displays T, then dialing mode is
set as Tone.
SETTING PABX CODE
1. In on-hook state, press and hold DEL key 3 seconds to set PABX code, LCD displays