Campomatic PI200 - Manual (Page 4)

3
GETTING STARTED
1. The unit requires 3 h1.5V AA batteries. Open the battery compartment cover and insert the
batteries in the right polarity, then close the cover (Proposal using alkali battery). There should
be time display on the liquid crystal screen after the batteries are inserted.
2. Insert one end of the line cord to the line jack of the base and the other end to the telephone
wall outlet.
3. Connect the handset and the unit with coiled line.
4. Setting the dialing mode to correct mode according to the directions from your local telecom.
5. Apply for the caller ID from your local telecom office.
RECEIVING A CALL
1. When a call comes, the telephone rings, and LCD displays the seq. number of the call, the
date, time, incoming number and the NEW icon.
2. If the same number is received again, and the previous call has not been reviewed, the LCD
displays REP icon.
When the incoming memory is full, the latest incoming number replaces the oldest number in
the memory
NOTE: For the phone to display incoming number and other information, you must have
an active Caller ID subscription with your local telephone exchange company.
¾ From handset
1. Pick up the handset and talk to the other party.
2. When finished, return the handset to the base.
¾ Switching to speakerphone
1. When using the handset, press key and return the handset to the base.
2. When finished, press key again.
¾ From speakerphone
1. When the telephone rings, press key and talk to the caller. For the other party to hear your
voice clearly, speak into the speaker from a distance of 32cm or less.
2. When finished, press key again.
NOTE: Generally telecom transmits the incoming message between the first ring and the second
ring. So please answer the phone after the second ring.
MAKING A CALL
¾ From handset
1. Pick up the handset.
2. When you hear the dial tone, dial the desired number.
3. The unit will start to time the conversation after 6 seconds.
4. When finished, return the handset to the base.