Campomatic DW911ES - Manual (Page 22)

The following things should be checked before starting the dishwasher.
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
1
The dishwasher is level and fixed properly
2 The inlet valve is open
3
There is a leakage at the connections of the conducts
4 The wires are tightly connected
5 The power is switched on
6
The inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced .
Water Outlet
Connect the water drain hose. The drain hose mu st be correctly fitted to avoid water lea ks.
Ensure that the water dra in hose is no t kin ked or squashed.
If th e sink is 1000 higher from the floor, the excess water in hoses cann ot be drained dire ctly
into the sink. It will be necessary to drain excess w ater from hoses into a bo wl o r suitable
containe r that is held outside and lower th an the sink.
How to Drain Excess Water From Hoses
Syphon Connection
The waste conne ction must be at a he ight less than 10 00 mm (maximum) from the b ottom of the dish.
The water drain hose sho uld be fixed .
20