Campomatic DW911ES - Manual (Page 20)

It is recommend t hat you run a was h cy cle with the
dishwasher empt y an d the n remove the plug from the
sock et, turn off the wa ter supp ly and leave the door of
the appliance slightly open. This will help the d oor
seals to last l onger and prevent odours from forming
within the appliance.
If the appliance must be moved, try to keep it in the
vertical position. If absolutely necessary, it can be
positioned on its back.
One of the factors that cau se odours to form in the
dishwasher is food th at remains tr apped in the seals.
Periodic cleaning with a damp sponge will prevent this
from occurring.
Ensure the voltage and frequency of the p ower being correspond s to
t hose on the rating plate. Only in sert the plug into an electrica l socke t which is earthed
prop erly. If the electrical socket t o which the a ppliance must be connected is not
appr opriate for the plug , replace the socket, rather than using a a daptors or the like as
t hey could cause ove rheating an d burns.
Plea se look at th e rating label to know the rat ing voltage and connect t he dishwasher to the app ropriate power supply.
Use the required fuse 10 amp , time delay fuse or c ircui t breaker recommended and provide separate circuit servi ng
only this appliance.
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adj acent cabinets or walls. T he dishwasher is equippe d with water supply and drain hoses th at can
be positioned either to the righ t or the left s ides to facilitate proper installation.
Once the appliance is positioned for levelling, the height of the dishwashe r
may be altered via adjustment of the screwing level of the feet. In any case,
the applia nce should not be inclin ed more than 2 .
Before cleaning or performing maintenance, always
remove the plug from the socket.
To cle an the e xterior a nd rubber p arts of the di shw asher,
do not use solvents or abrasive cle ani ng products.
Only use a clo th with warm so apy water.
To remove spots o r stains from the surface of the
interi or, use a cloth da mpened wit h water a n a little
vinegar, o r a cleaning pro duct mad e speci fically for
dishwashers.
Remove the Plug
No Solvents or Abrasive Cleaning
Moving the Appliance
Seals
After every wash, turn off the water supply to the
appliance and leave the door slightly op en so that
moisture and odours are not tra pped inside.
After Every Wash When not in Use for a LongTime
For personal safety:
Do not use an extension cord or an adapter plug
with this appliance.
Do not, under any circumstances, cut or remove the
earthing
Connection from the power cord.
18