BUG-O Systems Stiffener Welder - Manual (Page 6)

6
Three adjustments are used to achieve the shown normal work position. The
Corner Follower Adjustment Knob and Clamp (D) are used to move the gun
up and down the Racking Bar (G). The corner follower will pivot as required
at the racking bar to center the Wheel Assembly (A) in the workpiece corner.
Two knobs are used to move the Gun Up/Down (F) and Left/Right (E) once
the Wheel Assembly (A) is centered in the workpiece corner.
The spatter guard height is adjusted by loosening the spatter guard screws
and sliding the guard up or down. Retighten the screws.
HEAVY DUTY CORNER FOLLOWER(CON’T.)
NORMAL POSITION SHOWN
GUN LEFT/RIGHT
ADJUSTMENT (E)
CORNER FOLLOWER ADJUSTMENT
KNOB AND CLAMP (D) [HIDDEN]
RACKING BAR (G)
WHEEL ASSEMBLY (A)
SPATTER GUARD
GUN UP/DOWN ADJUSTMENT (F)
SPATTER GUARD SCREWS AND
SCREW SLOT
SPATTER GUARD