BUG-O Systems PBM-2000 - Manual (Page 9)

9
BEVELING PIPES
Special optional pipe beveling attachment PBM-2100 allows you to bevel pipes and curves. To prepare the
machine for work on pipes, take the flat slide off the machine and replace it with the pipe attachment. Move
the housing (9) to its “zero width of cut” position. Place machine on the edge of pipe, in such a way that the
milling tool touches the workpiece (drawing 2). Then, loosen bolts and move rollers symmetrically towards
the pipe so that they rest on it. Fasten both rollers. You can now adjust the required beveling angle.
IT IS NOT RECOMMENDED TO BEVEL PIPES WITH RADIUS LESS THAN 6" (150 mm).