4 ..........general information – BUG-O Systems PBM-2000 User Manual
Page 4
4
GENERAL INFORMATION
The beveling machine PBM-2000 is designed for milling steel edges prior to welding. It is reliable and simple
to use. The machine can be used for beveling straight and curved steel sheets and pipes. It allows you to
bevel steel edges between 15 and 60 degrees. Maximum width of cut is 3/4" (19 mm). When equipped with
a special attachment it can also work on pipes above 6" (152.4 mm) diameter.
Before you start work with the machine, please read these instructions carefully. Take spe-
cial note of safety recommendations.
PBM-2000 / PBM-2002
This manual is related to the following products:
See also other documents in the category BUG-O Systems Equipment:
- HOB-O (18 pages)
- Side Beam System (17 pages)
- Flame Cutting (34 pages)
- Trac-Bug (21 pages)
- Programmable Shape Machine (31 pages)
- Programmable Shape Machine (22 pages)
- K-BUG 1200 (21 pages)
- Programmable Gantry System (36 pages)
- CWP-5 (40 pages)
- CWP-7 (41 pages)
- CWP-11 (47 pages)
- CWP-18 (41 pages)
- CB-1P (37 pages)
- CB-3 (30 pages)
- CW-5 (34 pages)
- CWE-5 (40 pages)
- CW-5AX (41 pages)
- CW-7 (43 pages)
- Elbow Cutters 3rd Axis (14 pages)
- CW-11 (46 pages)
- CW-18 (41 pages)
- SE-4PD (48 pages)
- SE-4PTD (40 pages)
- SE-4PD (43 pages)
- FTS-1025 (17 pages)
- BVW-1000 (26 pages)
- AGS-4100 (46 pages)
- Standalone CDS Linear Weavers (20 pages)
- BGW-6000 (47 pages)
- Standalone Pendulum Weavers (18 pages)
- DC IV v.2 (22 pages)
- UNI-BUG II (21 pages)
- BEAM BUG III (23 pages)
- SPB-3000 (26 pages)
- Speed Weaver II (14 pages)
- UNI-BUG III (44 pages)
- CAS-2050 (20 pages)
- BUG-6554 (32 pages)
- CAS-2060 (20 pages)
- BUG-9874 (12 pages)
- STW-2000 (32 pages)
- STW-3000 (26 pages)
- Stiffener Welder (29 pages)
- MDS-1004 (14 pages)