BUG-O Systems Programmable Shape Machine - Manual (Page 16)

16
To program a complete new shape (press “A”).
Count the number of segments or operations and enter the total.
For each segment, ENTER
Type: select from 1 through 8
Quadrant: 1, 2, 3 or 4; refer to chart
Size: one or more dimensions per segment as described below; 100 per inch or 10 per mm
(depending on machine version ); or for time, 100 per second of delay.
Eg. 150 = 1.5", or for metric 375 = 37.5 mm.
Detailed description of Types:
Type 1. Clockwise (90 0 arc Segments):
Quadrant determined by which quarter of a full circle makes the arc. (See Chart #1).
dimensions required: Radius only (See Chart #2).
Type 2. Counterclockwise(90 0 arc Segments):
Quadrant determined by which quarter of a full circle makes the arc. (See Chart #1).
dimensions required: Radius only (See Chart #2).
Type 3. Line along X or Y axis:
Quadrant determined by direction of movement. (See Chart #1)
(East: 1, North: 2, West: 3, South: 4)
dimensions required: Length only (See Chart #2).
Type 4. angled Straight Line:
Quadrant determined by direction of movement. (See Chart #1)
(NE: 1, NW: 2, SW: 3, SE: 4).
dimensions required: (1) X-dimension; movement along X axis.
(2) Y-dimension; movement along Y axis.
Type 5. Functions:
Quadrant determined by selecting function. (See Chart #1)
1. Weld/Oxygen ON
Turn ON weld contact relay or cutting oxygen solenoid
dimensions required: None.
2. Weld/Oxygen OFF
Turn off weld contact relay or cutting oxygen solenoid.
dimensions required: None.
3. Wait For Start
Machine stops and waits until START/RUN button is pushed again.
dimensions required: None.
4. delay
Machine stops and holds position for a programmed time period, up to 99.99 seconds.
dimensions required: time in .01 second units. (eg. 2.5 seconds = 250)
daTa ENTRY REQUIREd FOR PROGRaMMING