Datamax DGL - Manual (Page 44)

44
Chapter 3
KO GPIO Output
PTX has its own GPIO configuration methods
KS Configure Scalable Font Cache Size
PTX Font cache is configured in PRINTER CONTROL Menu
P Enter Character Dump Mode
HexDump Mode is available in DIAGNOSTICS Menu
T Printhead Dot Pattern Test Label
Z Print Configuration and Dot Pattern Labels
DIAGNOSTICS -> Printer Tests
J Set Pause for each label
p Controlled Pause
These commands can be supported by using PAA to filter out the
commands, and have GPIO put the printer in Single Label Mode.
A panel-key can then be assigned by GPIO to either print the next
label (for
J), or disable pause mode again (for p).
Partially Supported Commands
t Test DRAM Memory Module
w Test FLASH Module
This command tests the DRAM / Flash, and reports back to the
host. DGL always reports ‘OK’ status.