BSS Audio sw9008iis Install Guide - Manual (Page 4)

Soundweb
TM
4
9008 Installation Guide
Rear Panel Details
Mains inlet
IEC power connector, for connection to mains supply (100-270V AC, 50/60Hz).
Mains fuse holder
Requires a 20mm T1A type fuse. Do not replace with anything other than the
recommended fuse.
Audio & Control connectors
9008 audio and control connections are via Klippon (also known as BL, Phoenix or
Combicon) pluggable terminal block connectors.
8 x 6-way female Klippon connectors are supplied for making these connections.
For audio and network cables and looms, see the Product Overview 2000 catalogue from:
Direct Cable Systems Ltd.
Tel: (020) 7485 0899
www.directcable.co.uk
Neutricon-Neutricon tour grade network cable.
P/N150001
Phoenix-XLR audio cable P/N100521
Audio Output wiring convention
Soundweb products provide cable shielding ‘back from the destination’ to eliminate
ground loop problems. Therefore, the shield (S) connection on an input is grounded,
whereas the shield connection on an output is floating (although connected via an
internal network to ground for EMC compliance).
Balanced wiring - The convention for balanced wiring (2-core plus shield) is:
Balanced connection 9008 connection
Pin 3 : Cold '-'
Pin 2 : Hot '+'
Pin 1 : Shield