BSS Audio sw9008iis Install Guide - Manual (Page 2)

Soundweb
TM
2
9008 Installation Guide
Regulatory Information
An example of this equipment has been tested and found to comply with the following
European and international Standards for Electromagnetic Compatibility and Electrical
Safety:
Emissions (EU):
EN55013 (1990)
Generic Immunity (EU): EN50082-1 (1997)
Electrical Safety (EU): EN60065+A11 (1993)
Electrical Safety (USA): UL6500/ETL (1996)
Electrical Safety (CAN): CAN/CSA-E65/ETLc (1994)
Radiated Emissions (USA): FCC parts 15 Class B
For continued compliance with international EMC regulations, it is important that all
cables be screened, and connected as follows:
•
Audio cable screens to their 9008 connector ground.
• Control cable screens to the ground screws adjacent to the connector.
Network cables should be of type CAT. 5
IMPORTANT SAFETY INFORMATION
Do not remove covers.
No user serviceable parts inside - refer servicing to qualified service personnel.
This equipment must be earthed.
It should not be necessary to remove any protective earth or signal cable shield
connections to prevent ground loops. Any such disconnections are outside the
recommended practice of BSS Audio and will render the EMC or safety certification
void.
Mechanical Installation
If the unit is likely to undergo extreme vibration through extensive road trucking and
touring, it must be supported at the rear and/or sides to lessen the stress on the front
mounting flange. Use either a ready-built rack tray or mount the 9008 unit between other
units. Damage caused by insufficient support is not covered by the warranty.
To prevent cosmetic damage to the front panel finish, use protective plastic cups under
the rack mounting bolts.