BSS Audio sw9008iis Install Guide - Manual (Page 3)

Soundweb
TM
9008 Installation Guide
3
Front Panel LED Functions
DSP Clip
Illuminated = indicates that the processed signal is clipping internally.
Network
Master
Flashing = the network is initialising. If the led continues to flash for
more than a few seconds, there is a cabling fault - either a double ring
error or a problem with one of the cable connectors.
Steady = this unit has become the clock master for the network.
Off = this unit is slaving to an external master clock.
Sync
Steady = indicates the presence of one or more valid network connections.
Flashing = there is a problem with the incoming network signal - check connections and/
or possibly the maximum cable length has been exceeded.
Activity
Flashing Yellow = indicates data transfer. The flashing is not regular, but dependent on
the rate of transfer.
Flashing Red = indicates bad data and is usually caused by network faults. Check
network connections, see Rear Panel details.
Power
Illuminated = indicates that the power supply is functioning.