Bronkhorst FLOW-BUS LabVIEW Driver - Manual (Page 14)

FLOW-BUS LabVIEW™ Driver Manual 9.17.078
Bronkhorst®
14
When everything is connected the VI can be used just like any other driver VI. The block diagram of the completed VI is shown
below.
Figure 10: Example VI
If you compare the image above to the image in chapter 3.2.2 or any other driver VI, you will see a lot of similarities. The only
differences are the entered values, and possibly the conversion of the data to write to the instrument. Therefore the easiest way to
make a new driver VI is to copy an existing one and change the necessary controls, indicators and values.