Bronkhorst BRIGHT (V2.00 and higher) - Manual (Page 4)

BRONKHORST HIGH-TECH B.V.
1 Scope of this manual
1.1 Introduction
The BRIGHT is a readout and operator module for Bronkhorst digital Mass Flow and Pressure Meters/Controllers. The
module not only allows reading of actual and total flow, simultaneously, but also features local operation, i.e. change
of setpoint, counter reset, setting of engineering units, fluid name and tag number, etc. Four push-buttons at the right
side of the device give access to a user-friendly menu. The bright 1.8” colour display is clearly visible over a wide angle,
due to state-of-the-art TFT-technology. The weatherproof (IP65) housing makes the module suitable for use in
industrial areas and the module can be mounted on the instrument or, using the mounting kit, on an adjacent wall or
panel and on the pipework.
Note
Because the BRIGHT uses the RS232 port of these instruments for communication, other RS232 communication is not
possible. When the instrument is connected with a bus-system like Profibus or DeviceNet, communication with this
bus-system will not be effected. Measure, setpoints and other parameters can be “read-and-write” by the BRIGHT or
via the bus-system.
9.17.048 Page 4